From: "Network Operations" <admin@isoc.net> Subject: RE: [Emerald] USR Total Control - Framed Route - Radius Date: Thu, 17 Oct 2002 09:51:14 -0400 Message-ID: <01e401c275e4$4215bf70$42056043@jtroheroffice>
Framed Subnet sounds like what I want.
ie: pipeline 50 get a framed-address for its wan interface
then I have been adding routes for a /30 or /28 subnet in the cli
to their framed address.
then they use one of the ip's for the Ethernet interface on the pipeline
and the remaining ip's on their network.
It sounds to me like you are saying I can do this with the
framed-subnet?
only problem is I cannot find that attribute :(
I am using emerald 2.5 and radius 2.something
-----Original Message-----
From: emerald-request@iea-software.com
[mailto:emerald-request@iea-software.com] On Behalf Of Billy Huddleston
Sent: Thursday, October 17, 2002 9:50 AM
To: emerald@iea-software.com
Subject: Re: [Emerald] USR Total Control - Framed Route - Radius
I never use Framed-Route unless they have more than 1 subnet..
Otherwise, I
just assign them a
static ip address with the Framed-Subnet.. They get the whole subnet
routed
to them that way..
I think it's net/subnet gateway metrix .. So... 192.168.0.0/24
192.168.2.1 1
I think.. Been a while since I've done one of those..
Thanks, Billy
----- Original Message -----
From: "Network Operations" <admin@isoc.net>
To: <emerald@iea-software.com>
Sent: Thursday, October 17, 2002 9:37 AM
Subject: [Emerald] USR Total Control - Framed Route - Radius
>
> Hello all,
>
> I am trying to figure out how to get Radius to assign
> a route to my hiper-arc for dial ISDN customers.
>
> The customers have static framed addresses assigned
> and I usually add the route in the hiper-arc thru the
> CLI but sometimes they get lost after a reboot.
>
> So I am trying to use the Framed-Route attribute but
> not sure what to put in the value? what is the proper
> format? Is it something like destination x.x.x.x
> gateway x.x.x.x metric x. Or is it the command I would
> use if I was doing it in the hiper-arc cli? ie:
> add route x.x.x.x/x gateway x.x.x.x metric x
>
> Anyone have any ideas?
>
> TIA
> John
>
> ------------
>
> This is a user supported list. If you require assistance from IEA
Software's
> Support Engineers, please check out our Support resources at
> http://www.iea-software.com/support.
>
> For more information about this list (including removal) go to:
> http://www.iea-software.com/support/maillists/liststart
>
------------
This is a user supported list. If you require assistance from IEA
Software's
Support Engineers, please check out our Support resources at
http://www.iea-software.com/support.
For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart