But I mentioned 2 problems : The first was regarding RadiusNT crashing.
And the second problem was about the modems not answering calls after failed
calls.
Which one do you encounter ?
- Danny
----- Original Message -----
From: Info Desk <info@olynet.com>
To: <ntisp@iea-software.com>
Sent: Thursday, May 20, 1999 11:58 PM
Subject: Re: [NTISP] Need help with my USR Netserver 16
> Four or five different ones starting with 3.x and now I am using 4.x.x. I
have
> had these for two years now. I find that I have to reboot them at least
once a
> week.
>
> Danny Sinang wrote:
>
> > What Netserver 16 firmware do you use ?
> >
> > - Danny
> >
> > ----- Original Message -----
> > From: Info Desk <info@olynet.com>
> > To: <ntisp@iea-software.com>
> > Sent: Thursday, May 20, 1999 11:44 PM
> > Subject: Re: [NTISP] Need help with my USR Netserver 16
> >
> > > I have two Netserver 16's and they do the same thing. I have had the
same
> > > problem with Radius NT as I have with 3COM's own Radius. I think it
is
> > > something to do with the Netserver code.
> > >
> > > Danny Sinang wrote:
> > >
> > > > Hello.
> > > >
> > > > I just bought a used USR Netserver 16 with firmware version 3.x .
> > > >
> > > > It answers all calls faithfully, but everytime it authenticates
against
> > > > RadiusNT 1.16.60 and sends accounting packets to it, RadiusNT
crashes.
> > > >
> > > > So I decided to upgrade the firmware to version 4.1.7 and see what
> > happens.
> > > >
> > > > The problem is, after a failed dialup attempt to any port in the
> > Netserver,
> > > > it won't allow any more calls. I set the Netserver to debug mode
(show
> > > > events) and it says something about "PPP : UNKNOWN compression" .
> > > >
> > > > I applied the 2 service releases that were reported to fix this
failure
> > to
> > > > answer calls, but it doesn't seem to work.
> > > > The latest service release is 4.1.77 dated December 3, 1998.
> > > >
> > > > Should I have set dip switch # 4 down to erase the flash
configuration
> > > > before I applied the service releases ?
> > > >
> > > > What could be the solution ?
> > > >
> > > > Does anybody here have RadiusNT 1.16.49 ? I heard it wasn't as
broken as
> > > > 1.16.60 .
> > > >
> > > > Danny Sinang
> > > > President
> > > > Uplink Technologies, Inc.
> > > > www.uplink.com.ph
> > >
>