Re: [RadiusNT] Assigned IP address

Ed Miller ( (no email) )
Fri, 16 Jul 1999 06:25:29 -0400

We used this same setup a few months back for another customer,
on this same PM3, so I don't think that is the problem.
It may be a problem with the router on the customers end.
I am going to dial in using the ip address and test it.

Any one else with an idea???

> Ed Miller wrote:
> >
> > Dale,
> >
> > We have a dialup customer with a dedicated line and an assigned
> > IP address. In the Radius settings we have
> > User-Service 'Framed-User'
> > Framed-Protocol 'PPP'
> > Framed-Address '216.116.2.39'
> > Framed-Netmask '255.255.255.0'
> >
> > The PM3 reports this address in the calls on line in Emerald
> > but we can not ping it. And they can not ping out to the world.
> >
> > I can ping into our system to the address of the PM3
> > 216.116.2.200 just fine. So I do not think that it is a
> > router problem. We used the same address for another
> > customer a few months ago and it worked fine.
> >
> > Is there another setting that we have to put in Emerald?
> >
> > If not anyone have any ideas??
>
> Can the PM3 ping the customer or Vice versa? Maybe there is
> a setting in the PM's routing table that is conflicting with
> this entry?
>
>
> --
>
> Dale E. Reed Jr. Emerald and RadiusNT
> __________________________________________
> IEA Software, Inc. www.iea-software.com
>
> For more information about this list (including removal) go to:
> http://www.iea-software.com/support/maillists/liststart

For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart