Re: Static IP can't surf

Rudy Komsic ( (no email) )
Sat, 18 Jul 1998 05:09:13 -0400

I had this problem and the way to resolve it EASILY was to turn on RIP on my
Router and RIP on my modem Chassis. After that Class Cs became a Breeze to
set up.

-----Original Message-----
From: Dale E. Reed Jr. <daler@iea-software.com>
To: Victor A. <victor@webjogger.net>
Cc: radiusNT@iea-software.com <radiusNT@iea-software.com>
Date: July 18, 1998 4:02 AM
Subject: Re: Static IP can't surf

>Victor A. wrote:
>>
>> We've assigned a Static IP address to one of our customers in Emerald and
>> under the Radius Tab we've setup the following configuration:
>>
>> User-Service Framed-User 6 2
>> Framed Protocol PPP 7 1
>> Framed Address xxx.xxx.xxx.xxx 8
>> Framed Netmask 255.255.255.0 9
>>
>> Well, the user logs on fine, Emerald shows the user with the Static IP
>> but.... the user can't do anything at all!! We had him connect to our
>> PR and to the PM3 no changes at all. He's unable to go onto the Internet.
>>
>> What else does one needs to do, the user is running Win95 and has tried
>> entering the Static IP info in DUN and the Network Icon of the CP, in both
>> cases same result.
>
>The typical cause of this is assigning the user an IP that isn't on
>the local ethernet of the PM or PR. At that point it turns into a
>routing problem.
>
>--
>Dale E. Reed Jr. (daler@iea-software.com)
>_________________________________________________________________
> IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs
> Internet Solutions for Today | http://www.iea-software.com