You have to restart RAS because these parameters are transmitted to each
modem when the service starts. The good news is you can do this from
the GUI administrator, at least you can for RAS.
No fix that I have heard about.
George
George G. Stossel, President Phone:
419.352.3568
DACOR, Inc. FAX: 419.353.0149
519 W. Wooster Street Sales: 800.447.5333
Bowling Green, OH 43402-2763 03 USA Email:
stossel@dacor.com
WWW: http://www.dacor.com/
-----Original Message-----
From: Danny Sinang [SMTP:danny@uplink.com.ph]
Sent: Monday, May 04, 1998 10:07 PM
To: RadiusNT@iea-software.com
Subject: Re: Does idle-timeout work in RRAS ?
George,
Thanks for the Tip.
Indeed, somewhere in the CurrentControlSet registry, I saw that
the modems
had S19=5 ( meaning disconnect if idle for more than 5 minutes )
eventhough
I set the modems to disconnect after 10 minutes in the NT
control panel.
I changed the registry setting to S19=10 .
Questions:
1. Will the change take place immediately or do I have to
restart the RRAS
or RAS service first ?
2. Is there a fix to this already ?
- Danny
-----Original Message-----
From: George G. Stossel <STOSSEL@DACOR.COM>
To: 'RadiusNT@iea-software.com' <RadiusNT@iea-software.com>
Date: Tuesday, May 05, 1998 9:03 AM
Subject: RE: Does idle-timeout work in RRAS ?
>Danny,
>
>Assuming the RRAS suffers the same problem as RAS under NT, the
problem
>is that the GUI does not set the same registry entry as the
software is
>looking at when the modems are programmed at service start up.
This can
>be cured by editing the registry for each modem in the pool to
establish
>the S##=# value that enables the idle time out for the given
modem.
>Please note that not all modems use the same S register to
record the
>idle timeout value.
>
>I can remember the registry path, but I got the information
from the M$
>support site, under RAS.
>
>George
>
>George G. Stossel, President Phone:
>419.352.3568
>DACOR, Inc. FAX: 419.353.0149
>519 W. Wooster Street Sales: 800.447.5333
>Bowling Green, OH 43402-2763 03 USA Email:
>stossel@dacor.com
> WWW: http://www.dacor.com/
>
>
>
> -----Original Message-----
> From: Danny Sinang [SMTP:danny@uplink.com.ph]
> Sent: Monday, May 04, 1998 7:22 PM
> To: RADIUSNT
> Subject: Does idle-timeout work in RRAS ?
>
> Hello.
>
> I'm using RRAS ( w/ hotfix applied ) and idle-timeout doesn't
>seem to be
> working.
>
> Does anybody have RRAS that has idle-timeout working ?
>
> Danny Sinang
> President - Uplink Technologies, Inc.
> ( Provider of "Clean" Internet Access )
> www.uplink.com.ph
> danny@uplink.com.ph
>
>
> ----------------------------------------------------------
> RadiusNT Mailing List lists@iea-software.com
>
> ----------------------------------------------------------
> RadiusNT Mailing List lists@iea-software.com
>
----------------------------------------------------------
RadiusNT Mailing List lists@iea-software.com