>OK, but is there a command to start/stop a service remotely (=from
>another NT machine authenticated to the domain)?
>I think I saw a trick without AT somewhere, but I can't remember _where_
>:(
>It was something close to 'net stop servername\servicename', but this
>one doesn't work, and I'm unable to find anything related in the NT
>docs.
>Any hints?
>cu, Peter
>
>>-----Original Message-----
>>From: Dale E. Reed Jr. [SMTP:daler@iea.com]
>>Sent: Sunday, April 20, 1997 2:45 AM
>>To: RadiusNT@emerald.iea.com
>>Subject: Re: start/stop service
>>
>>CypressNet wrote:
>>>
>>> I'm sure this question has been answered here a million times, and
perhaps
>>>someone can point me in the direction of searchable archives, but:
>>> How do I start and stop RadiusNT (when running as a service) so that
it
>>>will reload the users file? Or, is there something else that I should do
to
>>>get it to reload the file when I make changes? Starting and stopping
from
>>>the control panel is dandy, just not very "automatable."
>>
>>You can create an AT job to do it:
>>
>>Net Stop RadiusNT
>>Net Start RadiusNT
>>
>>--
>>Dale E. Reed Jr. (daler@iea.com)
>>_________________________________________________________________
>> IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs
>> Internet Solutions for Today | http://www.emerald.iea.com
>>
>> ----------------------------------------------------------
>> RadiusNT Mailing List listserver@emerald.iea.com
>>
>
> ----------------------------------------------------------
> RadiusNT Mailing List listserver@emerald.iea.com
>