Re: Emerald Online status

Dale E. Reed Jr. ( (no email) )
Thu, 27 Feb 1997 10:20:17 -0800

Mauricio Marquez wrote:
> I'm using radiusnt 6.0 and Emerald 2.0.75 with a Cisco 2511 and a Computone
> PowerRack.
> The authentication is working quiet well. The problem I'm having is when I
> use Emerald's Online Tab:
> 1. Logs on the Cisco are displayed, but not the username in the port or the
> ip address of the port (I have configured -and saved- each port's ip address
> in the administrator).
> 2. Logs on the PowerRack are not displayed at all. I can't see what ports
> are being currently used.

You need to run RadiusNT in -x15 debug mode and see what errors
(if any) are being sent. Also check your logfile. Until I can see
the accounting debug, I don't know what advice to give. :(

-- Dale E. Reed Jr.  (       IEA Software, Inc.      |  RadiusNT, Emerald, and NT FAQs Internet Solutions for Today  |