> Brian Baker wrote:
> >
> > I installed 4 pm30 and have been running a pm3 at another location.
> > Everything has been working fine with the pm3. But with the pm2 the
connect
> > rate on the online screen does not show. I thought I read somewhere the
> > attbr. 64 for connect rate(?) and 77 for connect rate(77 seems to work
for
> > the pm3 but not the pm2).
> > Question : should I put in another attbr. of 65 for connect?
>
> The PM2 is an analog device and doesn't support connect-info.
>
> > Different topic
> > I have been running 3 pm2 without a problem. I installed the 4th pm2. In
the
> > Rad log I se a username then the data field has garbage in it. Any Ideas
> > where to start looking?? Why did the first three setup and work with a
> > hitch... but the fourth(programmed line for line the same..except for ip
> > pool) only shows the data a user sends as strange characters.
>
> The garbage means the secret defined in the PM2 doesn't match the secret
> defined in the Emerald Admin, RadiusNT, servers entry for the PM2.
>
>
>
> --
>
> Dale E. Reed Jr. Emerald and RadiusNT
> __________________________________________
> IEA Software, Inc. www.iea-software.com
>
> For more information about this list (including removal) go to:
> http://www.iea-software.com/support/maillists/liststart
>
For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart