[Emerald] Just a quickie!!

Brian Baker ( (no email) )
Tue, 30 Nov 1999 15:46:57 -0500

I installed 4 pm30 and have been running a pm3 at another location.
Everything has been working fine with the pm3. But with the pm2 the connect
rate on the online screen does not show. I thought I read somewhere the
attbr. 64 for connect rate(?) and 77 for connect rate(77 seems to work for
the pm3 but not the pm2).
Question : should I put in another attbr. of 65 for connect?

Different topic
I have been running 3 pm2 without a problem. I installed the 4th pm2. In the
Rad log I se a username then the data field has garbage in it. Any Ideas
where to start looking?? Why did the first three setup and work with a
hitch... but the fourth(programmed line for line the same..except for ip
pool) only shows the data a user sends as strange characters.

For more information about this list (including removal) go to: