Re: [NTISP] Disconnecting Problem

( )
Tue, 24 Aug 1999 12:19:39 -0400 (EDT)

We have to much latency between some of our pops. The ascends send check
point timers every 27 seconds. So yuo get them resent twice maybe three
times on a 60 second timeout. I should of clarified the numbers. I Use
45seconds if I don't we always miss the ones from the remote pops.


Matthew S. Bailey, President Journey Communications, Inc. PO Box 2003
(517) 779-2400 Mt. Pleasant, MI 48858

Inexpensive Wholesale Services for Michigan --

On Tue, 24 Aug 1999, Dale E. Reed Jr. wrote:

> wrote:
> >
> > Your not getting the Accounting stop record from the Ascend's... Pretty
> > typical here until we went to 7.0.4 TAOS and set high delay times on the
> > accounting information.. Someone at iea-software might ahve a better idea.
> > We do a check every morning to see if there are any obvious problems..
> I ran into a situation the other day where setting the accounting delay
> on a MAX to 60, caused it to always send two accounting records. It was
> real wierd. Typical probably with the Ascend are caused by an incorrect
> accounting timeout setting. It should be 5-10 seconds. Don't set it
> any different, or you may get undesirable results.
> --
> Dale E. Reed Jr. Emerald and RadiusNT
> __________________________________________
> IEA Software, Inc.
> For more information about this list (including removal) go to:

For more information about this list (including removal) go to: