Danny Sinang wrote:
> What Netserver 16 firmware do you use ?
>
> - Danny
>
> ----- Original Message -----
> From: Info Desk <info@olynet.com>
> To: <ntisp@iea-software.com>
> Sent: Thursday, May 20, 1999 11:44 PM
> Subject: Re: [NTISP] Need help with my USR Netserver 16
>
> > I have two Netserver 16's and they do the same thing. I have had the same
> > problem with Radius NT as I have with 3COM's own Radius. I think it is
> > something to do with the Netserver code.
> >
> > Danny Sinang wrote:
> >
> > > Hello.
> > >
> > > I just bought a used USR Netserver 16 with firmware version 3.x .
> > >
> > > It answers all calls faithfully, but everytime it authenticates against
> > > RadiusNT 1.16.60 and sends accounting packets to it, RadiusNT crashes.
> > >
> > > So I decided to upgrade the firmware to version 4.1.7 and see what
> happens.
> > >
> > > The problem is, after a failed dialup attempt to any port in the
> Netserver,
> > > it won't allow any more calls. I set the Netserver to debug mode (show
> > > events) and it says something about "PPP : UNKNOWN compression" .
> > >
> > > I applied the 2 service releases that were reported to fix this failure
> to
> > > answer calls, but it doesn't seem to work.
> > > The latest service release is 4.1.77 dated December 3, 1998.
> > >
> > > Should I have set dip switch # 4 down to erase the flash configuration
> > > before I applied the service releases ?
> > >
> > > What could be the solution ?
> > >
> > > Does anybody here have RadiusNT 1.16.49 ? I heard it wasn't as broken as
> > > 1.16.60 .
> > >
> > > Danny Sinang
> > > President
> > > Uplink Technologies, Inc.
> > > www.uplink.com.ph
> >