If so - or possibly anyway - you may have to supply NT with specific
drivers - try the adaptec site for these - there is a special way of
installing the drivers during the pre-install section of NT Setup which
involves pressing things quickly.
I had this problem with a Raid card - it was me not pressing the right
keys quick enough.
M@t :o)
-----Original Message-----
From: Mark Tran [mailto:mpt@gdex.net]
Sent: 07 April 1999 16:43
To: ntisp@iea-software.com
Subject: Re: [NTISP] nt 4.0 and 9.1 scsi
What kind of SCSI adapter are you using? When you boot up your computer
from the installation disk, hit the F5 key when it starts to load the
drivers for installation. Then load your SCSI controller driver from
diskette. It will then recognize your drive.
At 11:17 AM 4/7/99 -0400, you wrote:
>NT won't install on my 9.1 gig scsi drive. and it installed once before
on it.
>a motherboard failure cuz me to replace the m.b. then nt would not come
up.
>so i went to reinstall and it hasn't come up since to install.
>it goes to the point of detecting the ide cdrom and the adaptec 2940uw
>adapter then
>when i continue it says no hard disk found in the computer.
>
>help please driving me crazy, i am searching m.s. site but haven't
found the
>answer yet,
>
>thanks
>md
>