1. open your radconfigs table
2. under the colum for account ID enter the account ID matching that user =
=20
from your subaccounts table, make sure it's accountID No. and not customerID
No.
3. under the colum for radattributeID enter 8 for framed-address
4. under the dtat colum enter the i.p. number xxx.xxx.xxx.xxx
5. new row, same accountID
6. under the colum for ardattributeID enter 9 for framed-netmask
7. under the data colum add the netmask for this i.p.=20
8. close
you may not need to do 5,6, and 7 if all your i.p's are in the same netmask=
as
your NAS's i.p. pool
be sure to verify that this i.p. and netmask is routable by your NAS
next time the caller connects, he/she should get this i.p.
paul woo
elp networks
el paso, texas
At 02:00 PM 8/6/99 -0300, you wrote:=20
>
> Hi !=A0=A0=A0=20
> =A0=A0=A0 I need assign 1 ip to an user, What is the correct mode to do=
it.
> If y modify radconfigs its like nothing !
> =A0=A0=A0=A0=A0Where must I modify , where is "framed user" where must I=
put the fixed
> IP.
> =A0
> =A0=A0=A0 =A0=A0=A0 =A0=A0=A0 =A0=A0=A0 PLEASE HELP !
> =A0=A0=A0 =A0=A0=A0 =A0=A0=A0 =A0=A0=A0 =A0=A0=A0 Thank you!
************************************
Paul Woo
ELP NetWorks, Inc.
1401 Montana, Suite L
El Paso, Texas 79902
voice 915.533.8617
fax 915.533.9831
http://www.elpn.com
*************************************
For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart