1. RadiusNT runs in -x15 mode (usually, unless it "forgets" to use ODBC,
which I can usually resolve by resaving the config again).
2. Installing as a service (Radius.exe -install or via the Admin, gone both
ways)
3. Attempting to start the service results in "Could not start the RadiusNT
service...Error 1067: The process terminated unexpectedly"
Why does the Admin lose the configuration when you start it sometimes?
Where is it storing this information?
Is there a documented approach to solving the problems with getting this
going as a service.
Using version 2.5.162
---------------------------------------
Blake Eitniear