RE: [RadiusNT] radius.exe 2.5.175

Michael Saunders ( (no email) )
Tue, 18 May 1999 09:57:07 +1000

My annex box now supports pre-authentication. (before the modem answers works on cli)

Dave is there anyway I can make radius nt also support authenticating people in this manner

Michael Saunders

PS Dave how is your FreeBSD box
-----Original Message-----
From: David Sovereen [SMTP:dave@tm.net]
Sent: Tuesday, May 18, 1999 4:14
To: radiusnt@iea-software.com
Subject: Re: [RadiusNT] radius.exe 2.5.175

>There was a re-order in the way RadiusNT checks the validity of a
>request coming in (from a legit ip, valid username, etc). However,
>I don't see how any client could make a request without being in
>the servers table, unless it previuosly was failing the validity
>check ABOVE where it checks to see if its from a legit IP (although,
>checking the IP is one of the first things it does).

Makes sense to check IP address first. FWIW, the monitoring system doesn't
make an actual request. It only checks for the UDP port to be open and
responsive. The re-ordering the validity check caused an error we've never
seen before. By simply adding a servername and IP address to the servers
table, we are able to test again.

>We've been working on trying to cleanup/reformat a lot of the uneeded
>debugging and make sure its under the correct section. I'll see about
>correcting these.

Sounds good.

Dave

===================================================
I N T E R N E T F O R B U S I N E S S
Mercury Network http://www.tm.net/
129 Ashman St / P O Box 117 Voice: 517-837-3790
Midland, MI 48640-0117 Fax: 517-837-3780
===================================================