Re: [Emerald] Temporary and Permanent Extend, and Default Value for

Dale E. Reed Jr. ( (no email) )
Sun, 10 Oct 1999 10:58:45 -0700

david leigh wrote:
>
> Hi All
>
> I am trying to find the field which controls the temporary and permanent
> extend values in the MasterAccounts and SubAccounts table. There is a field
> called 'extension' which controls one of them (I forget which right now, but
> think it was temporary) but I cannot find anything to handle the other.
> Where can I find this field and can I just use a simple SET command to have
> them all changed to a default value.

Temp Extend is Extension
Perm Extend is OverDue

> Question two...
> How do I go about changing the default value that pops up in the RADIUS
> section of an account when I choose to add the attribute User-Service? At
> the moment the default is Login-User but most of our accounts are
> Framed-User. There is a bug in Emerald which causes the User-Service to
> revert to Login-User when *any* change is made to the Radius values. I
> figure that if Framed-User was the default value it would revert back to
> that and hence there would be no discernible problem for us.

There is no default. It sorts them based on the value.
The bug you note has been addresses in later versions of Emerald that
you can get from support.

-- 

Dale E. Reed Jr.      Emerald and RadiusNT__________________________________________IEA Software, Inc.    www.iea-software.com

For more information about this list (including removal) go to:http://www.iea-software.com/support/maillists/liststart