The problem is that it is trying to match the NASIdentifier attribute
with the IP Address you specified in the servers table. However, the
NAS-Identifier shown below isn't an IP Address. One way to work around
this is to add a second server in the Emerald Admin with an IP address
of "comserv2". Then things should start appearing.
> Here's an excerpt from my accounting log:-
>
> radrecv: Request from host cb3a192e code=4, id=20, length=139
> Acct-Status-Type = Start
> Acct-Session-Id = "35A19CC7D6"
> Acct-Delay-Time = 0
> User-Name = "terry"
> NAS-Identifier = "comserv2"
> NAS-Port = 3
> NAS-Port-Type = Async
> User-Service = Framed-User
> Framed-Protocol = PPP
> Framed-Address = 203.58.25.47
> Framed-Routing = Broadcast-Listen
> Framed-MTU = 1500
> Framed-Compression = Van-Jacobsen-TCP-IP
> Framed-Compression = 2
> Framed-IPX-Network = 0
> Framed-AppleTalk-Network = 0
> Idle-Timeout = 600
> Session-Timeout = 0
>
> SQL Statement: INSERT INTO Calls
> (CallDate,AcctStatusType,AcctSessionId,AcctDelayTime,UserName,NASIdentifier,
> NASPort,NASPortType,UserService,FramedProtocol,FramedAddress) VALUES
> (GetDate(),1,'35A19CC7D6',0,'terry','comserv2',3,0,2,1,'203.58.25.47')
>
-- Dale E. Reed Jr. (daler@iea-software.com)_________________________________________________________________ IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs Internet Solutions for Today | http://www.iea-software.com