This is a known problem with 1.16.60. Upgrade to RadiusNT 2.2 or
higher and it will work.
> -----Original Message-----
> From: Dale E. Reed Jr. <daler@iea-software.com>
> To: radiusnt@iea-software.com <radiusnt@iea-software.com>
> Date: Tuesday, May 19, 1998 1:28 AM
> Subject: Re: Calls-Online
>
> >Thomas Spaulding wrote:
> >>
> >> Before I get too much further into it.....Should this be able to work
> >> properly with RadiusNT 1.60, MSAccess97, NT4.0 (sp3/Hotfixes), 3COM TCHs
> >> with T1s ?
> >>
> >> If so is there a web site with setup instructions? I can see the IP
> >> addresses of the server but no data shows up when I run the Query :-(
> >
> >Assuming you have manual calls update enabled and you have populated your
> >Server Ports table with the ports for the TCHs, then it should work
> >fine.
> >
> >--
> >Dale E. Reed Jr. (daler@iea-software.com)
> >_________________________________________________________________
> > IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs
> > Internet Solutions for Today | http://www.iea-software.com
-- Dale E. Reed Jr. (daler@iea-software.com)_________________________________________________________________ IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs Internet Solutions for Today | http://www.iea-software.com