Re: ascend-idle-limit

Dale E. Reed Jr. ( (no email) )
Thu, 14 May 1998 13:37:46 -0700

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Previous message: Dale E. Reed Jr.: "Re: Specific Vendor Attributes"
Next message: Dale E. Reed Jr.: "Re: "Your account is Expired" for all users."
Maybe in reply to: Frank Wanicka: "ascend-idle-limit"
Next in thread: Frank Wanicka: "Re: ascend-idle-limit"

Frank Wanicka wrote:
>
> sorry if this was discussed before. i'm running 2.5.107.
>
> i just noticed radiusnt is stripping the last zero off of whatever i enter
> for ascend-idle-limit. i had 1200 and it was showing 120 as passed to the
> client in debug mode. i upped it to 12000 and now it shows 1200. i haven't
> confirmed that this is what the client is getting. this is what is shown in
> x15 mode.

Are you looking at the data or value field? It doesn't matter when the
data field is for this, only the value (integer) field is used. Radlogin
should show you what the NAS is getting for the attribute.

-- Dale E. Reed Jr.  (daler@iea-software.com)_________________________________________________________________       IEA Software, Inc.      |  RadiusNT, Emerald, and NT FAQs Internet Solutions for Today  |   http://www.iea-software.com

Previous message: Dale E. Reed Jr.: "Re: Specific Vendor Attributes"
Next message: Dale E. Reed Jr.: "Re: "Your account is Expired" for all users."
Maybe in reply to: Frank Wanicka: "ascend-idle-limit"
Next in thread: Frank Wanicka: "Re: ascend-idle-limit"