RadiusNT install trauma.

John Scrivner ( john@scrivner.com )
Fri, 9 May 1997 21:48:08 -0700

Please help a newbie. I have just installed Radius NT and I followed Dale's
instructions to the letter. When I run "radius -x15 -A" the user file looks
like it doesn't load. I did a copy/paste on the example for the test/test
account Dale said to use to test in debug mode. I am nearly sure I have this
formatted correctly. Below is what my screen shows now when running "radius
-x15 -A". Below that is a copy/paste of my user file. Any help is appreciated.

---------------------
Radius -x15 -A Screen
---------------------
-------------------------------------snip---------------------------------------
Radius NT 1.16.60 2/7/97 Copyright <c> 1996 IEA Software, Inc.
All Rights Reserved, Worldwide

Param: Debug Level: 15
Param: Require Authentication for Accounting packets
Initializing Winsock...
Client:208.146.11.65:208.146.11.65:secret

Loading users...
c:\radius\radius.exe: Parse error -98 for user dan
0 users loaded!

Radius NT is ready to receive requests!
-------------------------------------snip---------------------------------------

---------
user file
---------
-------------------------------------snip---------------------------------------

test Password = "test"
User-Service = Framed User

dan Password = "bubba"
User-Service = Framed User
-------------------------------------snip---------------------------------------

The user file did not work when I only had the "test" user in either. I put
in the "dan" user to see if the radius was even seeing the user file.
Obviously it is seeing it, as the screen shows above it is causing a Parse
error -98. Any suggestions or help is appreciated.

John Scrivner (john@mountvernon.net)
President (john@scrivner.com)
Mount Vernon Net Inc. (johnscrivner@cablenow.com)