Re: Radius 1.60 load error

Dale E. Reed Jr. ( (no email) )
Fri, 25 Apr 1997 02:19:42 -0700

gwatkins@bmmhnet.com wrote:
>
> I did setup the admin but if I understand it right that only applies
> if running as a service. I did not install 60 to run as a service. I
> am also not running 49 as a service either. I simply setup an item in
> the startup group to load Radius with the following command line:

No. The RadiusNT sets the "Defaults" for RadiusNT. You can over-ride
this on the command line for debug. But if you specify options in the
admin, and just start Radius with "radius -x15" all those are in affect.

> radius -x15 -b
>
> This works fine for 49 but not 60.

Do a cut/paste of what follows after this. You may need to go
into the admin and specify the directory information, though.
The default typically doesn't work.

-- Dale E. Reed Jr.  (daler@iea.com)_________________________________________________________________       IEA Software, Inc.      |  RadiusNT, Emerald, and NT FAQs Internet Solutions for Today  |    http://www.emerald.iea.com