I am currently setting up a new ISP service and am having a little trouble
configuring RadiusNT. When I run a modified 'users' file, I get the message
'0 users loaded!
Here's what I've done so far - I started off by copying the 'users.example'
file to 'users' and ran 'RadiusNT -x15 -A' as described in the install
notes and all ran fine. I received the message 'x Users Loaded'. I dialed
into my system using the 'test' user id and it all worked. Great! I then
started to build my own user file but when I tried it out I rxed the
message '0 users loaded'. I checked for tab spacing, all is fine. Next step
I copied 'users.example' to 'users' again and tested. Loaded fine. I then
added a user to this file and tried it, '0 users loaded!'. Hmmm, I said to
myself. Next I copied 'users.example' to 'users' again and went to the
blank line in the comments section in the header and typed 'blah blah
blah'. I did this in the *comments* section along with all the other
comments. I then ran RadiusNT and '0 users loaded!'.
What am I doing wrong? It seems that whenever I make a change to the users
file it will not load. I have checked ownership, rights, and file
attributes. The only difference is the date stamp.
My system is NT 4.0 and a livingston PM2e-R
Any assistance greatly appreciated!
Andrew Barton
RedShift Information Technology
redshift@istar.ca (for now)