CHAP (what you show below) does NOT work with ODBC mode. Set your
AUth type from BOTH to PAP, and it will work fine.
> Following is the message from Radius Server;
> ########################################################
> NAS-Identifier = 207.22.142.12
> NAS-Port = 20102
> User-Service = Framed-User
> Framed-Protocol = PPP
> State = ""
> Acct-Session-Id = "16810"
> rad_authenticate_ODBC()
> Challenge-Response = "\001Zo\201A\225\030e\322\027>\305\256\274\376\351r"
> Decrypted Password: ¦¦¦+x¶B!C·Æ=¦4~
> Allocating Statement...
>
> SQL Statement: Select DateAdd(Day, ma.extension, maExpireDate), DateAdd(Day, sa
> .extension, saExpireDate), sa.AccountID, sa.AccountType, sa.Password, sa.Login,
> sa.Shell From MasterAccounts ma, SubAccounts sa Where (sa.Login='frenchkc' or sa
> .Shell='frenchkc') AND ma.CustomerID=sa.CustomerID and sa.Active<>0 and ma.Activ
> e<>0
>
> Freeing SQL Statement...
> LOG: User: frenchkc Not found
>
> User: frenchkc Not found
> Sending Reject of id 247 to cf168e0c (max1.???.???)
> ########################################################
>
> If I configure dial-up networking "bring up terminal after dialing"
> then I can log in OK.
>
> Any thoughts pointers appreciated.
>
> ----------------------------------------------------------
> RadiusNT Mailing List listserver@emerald.iea.com
-- Dale E. Reed Jr. (daler@iea.com)_________________________________________________________________ IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs Internet Solutions for Today | http://www.emerald.iea.com