:) I'm running 1.5.1e and it's not working out.
Mauricio
>> From: Mauricio Marquez <mmarquez@mail.eic.com.mx>
>> To: emerald@emerald.iea.com
>> Subject: Re: Emerald Online status
>> Date: Thursday, February 27, 1997 3:51 PM
>>
>> At 10:20 AM 02/27/97 -0800, you wrote:
>> >Mauricio Marquez wrote:
>> >>
>> >> I'm using radiusnt 6.0 and Emerald 2.0.75 with a Cisco 2511 and a
>Computone
>> >> PowerRack.
>> >>
>> >> The authentication is working quiet well. The problem I'm having is
>when I
>> >> use Emerald's Online Tab:
>> >>
>> >> 1. Logs on the Cisco are displayed, but not the username in the port
>or the
>> >> ip address of the port (I have configured -and saved- each port's ip
>address
>> >> in the administrator).
>> >> 2. Logs on the PowerRack are not displayed at all. I can't see what
>ports
>> >> are being currently used.
>> >
>> >You need to run RadiusNT in -x15 debug mode and see what errors
>> >(if any) are being sent. Also check your logfile. Until I can see
>> >the accounting debug, I don't know what advice to give. :(
>>
>> Ok, here's an attachment of what radius shows in debug mode when someone
>> connects to the PowerRack (powerrack.txt). The radius logfile didn't show
>a
>> thing aside of what it had before that call. I also noticed that when
>> disconnecting, radius didn't show a thing in debug mode.
>>
>> >--
>> >Dale E. Reed Jr. (daler@iea.com)
>>
>> Thanks,
>>
>> Mauricio
>>
>> Enlace Internacional de Comunicaciones
>> Internet Services and Consulting
>> Phone: 528.346.4667 FAX: 528.345.6987
>> http://www.eic.com.mx e-mail:mmarquez@mail.eic.com.mx
>>
>
> ----------------------------------------------------------
> Emerald Mailing List listserver@emerald.iea.com
>
>