From: "Jeffrey M Donley" <jeffd@lmf.net> Subject: RE: [Emerald] Emerald V4 on multihomed server Date: Wed, 24 Apr 2002 19:32:19 -0400 Message-ID: <DDEDJOHLDAIGFOJIBADAEEBGCEAA.jeffd@lmf.net>
Doug,
You can not bind Emerald web server to run on a single IP. What I done was
close the port for the IP address I did not want emerald to listen on at my
router level. Depending on the OS you are running there are several server
level filters you can do also to keep emerald from listening on the other IP
addresses.
Jeff
-----Original Message-----
From: emerald-request@iea-software.com
[mailto:emerald-request@iea-software.com]On Behalf Of Doug Harpster
Sent: Wednesday, April 24, 2002 4:21 PM
To: emerald@iea-software.com
Subject: [Emerald] Emerald V4 on multihomed server
Hi folks.
Is there is a way to tell Emerald V4 to use a particular IP address on a
mutihomed server. For example, a server has two IP addresses of
192.168.1.1 and 192.168.1.2, but you only want Emerweb to run on
192.168.1.1. Is there a config file where I can state this? Thanks.
Doug
------------
This is a user supported list. If you require assistance from IEA Software's
Support Engineers, please check out our Support resources at
http://www.iea-software.com/support.
For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart
.