how can i check them?
- sci
----- Original Message -----
From: "Dale E. Reed Jr." <daler@iea-software.com>
To: <radiusnt@iea-software.com>
Sent: Friday, September 29, 2000 3:56 AM
Subject: Re: [RadiusNT] URGENT: AcctStatusType is not setting to 2 when user
disconnects.
> sci wrote:
> >
> > what could be the causes?
> > 1. Stop packet didnt received?
> > 2. if Stop Packet Received then the AcctStatusType was not 2, it could
be 1
> > or 3?
> > 3. RAD was unable to update the status type in the DB?
> > 4. NAS is not configured properly for RADIUS
> >
> > any ideas?
>
> Run RadiusNT in -x15 debug mode and look for the Accounting Stop
> packets. Are you receiving them? Are you getting an error on
> the accounting side?
>
> > + how do i manage the CLI option?
> > can i get connecting user's CLI at any stage of authentication and write
my
> > custom SPs or add some code in existing SP to verify it. could it be
done in
> > RAD 3.0? or 2.5?
>
> Not in 2.5. I assume you want to check for multiple possible CLI
> values for a single account?
>
>
> --
>
> Dale E. Reed Jr. Emerald and RadiusNT/X
> __________________________________________
> IEA Software, Inc. www.iea-software.com
>
> For more information about this list (including removal) go to:
> http://www.iea-software.com/support/maillists/liststart
>
For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart