RadiusNT 3.0.172
MS SQL 7 with Service Pack (not sure if it's 1 or 2 at this moment)
Data shows up in the debug window like...
radrecv: Request from host 3fd9348a (CCS5300) code=4, id=242, length=748
NAS-Identifier = 6x.xx.xx.138
NAS-Port-Type = Async
User-Name = ""
Called-Station-Id = "1#0xxxxxxxxxxxxxxx#"
Acct-Status-Type = Stop
User-Service = Login-User
Gateway-Name = "h323-gw-id=CCS5300."
Connection-Id = "h323-conf-id=62FCD067 4949BA5D 0 4FEC20C"
Cisco-AVPair = "h323-incoming-conf-id=62FCD067 4949BA5D 0 4FEC20C"
Call-Direction = "h323-call-origin=answer"
Call-Type = "h323-call-type=VoIP"
Setup-Time = "h323-setup-time=13:12:13.121 UTC Wed Jul 26 2000"
Connect-Time = "h323-connect-time=13:12:24.633 UTC Wed Jul 26 2000"
Disconnect-Time = "h323-disconnect-time=13:14:32.733 UTC Wed Jul 26
2000"
Disconnect-Cause = "h323-disconnect-cause=10"
Voice-Quality = "h323-voice-quality=11"
Remote-Gateway-Id = "h323-remote-address=208.231.xx.xx"
Acct-Session-Id = "000005C5"
Acct-Input-Octets = 73040
Acct-Output-Octets = 130940
Acct-Input-Packets = 3652
Acct-Output-Packets = 6547
Acct-Session-Time = 128
Cisco-AVPair = "h323-ivr-out=Subscriber:Unknown"
Cisco-AVPair = "pre-bytes-in=0"
Cisco-AVPair = "pre-bytes-out=0"
Cisco-AVPair = "pre-paks-in=0"
Cisco-AVPair = "pre-paks-out=0"
Cisco-AVPair = "nas-rx-speed=0"
Cisco-AVPair = "nas-tx-speed=0"
Acct-Delay-Time = 10
Sending Accounting Ack of id 242 to 3fd9348a (CCS5300)
Resp Time: 16 Auth: 0/0 -> 0 Acct: 1/0/0 -> 1
But never shows up an an SQL Query.
Other data from other hosts *DOES* record ok as far as we can tell.
Other data *LOOKS* the same other than which NAS is sending the data.
Has anyone seen this before?
Could this be a RadiusNT Setting problem?
No Errors are showing up in Radius Debug screens!
Thanks,
=============
Denny Figuerres
denny@figuerres.com
For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart