RE: [NTISP] MS VPN and firewall setup

Ronnie Franklin ( (no email) )
Fri, 14 Apr 2000 22:54:21 -0500

You should allow the ports that PPTP uses as that is what most MS VPNs use.
MS and Cisco have lots of articles on setting up VPNS and what ports are
needed...

> -----Original Message-----
> From: ntisp-request@iea-software.com
> [mailto:ntisp-request@iea-software.com]On Behalf Of Dan B.
> Sent: Friday, April 14, 2000 5:51 PM
> To: ntisp@iea-software.com
> Subject: [NTISP] MS VPN and firewall setup
>
>
> Hi Folks;
> How do folks allow VPN routing through ISP networks to corporate LANs?
> What specifically I need to know is that how to allow Microsoft VPN
> clients to go through our network and connect to corporate LANs, my
> current firewall implementation (using Cisco sccess-list) is not allowing
> VPN traffic through.
> I thought the Cisco MS deal was to use gre protocol for VPN routing??
> i.e
> access-list 101 permit gre any to <my network IP>
>
> Dan
>
>
> For more information about this list (including removal) go to:
> http://www.iea-software.com/support/maillists/liststart
>

For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart