Re: [RadiusNT] Dual Call Records Problem

Salman Karim ( (no email) )
Thu, 13 Jan 2000 11:16:24 PDT

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Previous message: Dale E. Reed Jr.: "Re: [RadiusNT] Netserver OID"
Next message: Herman verschooten: "[RadiusNT] .209 <> VSA"
Maybe in reply to: Salman Karim: "[RadiusNT] Dual Call Records Problem"

How to set TimeOut on PortMaster 2 ?

Salman

---------- Original Message ----------------------------------
From: hostmaster@interaxs.net
Reply-To: radiusnt@iea-software.com
Date: Wed, 12 Jan 2000 10:05:43 -0500

>Salman,

I don't think the problem is a trigger. It sounds as if your NAS is sending
multiple accounting records. This is probably caused by the timeout on the
NAS being set too short.

Jim

At 06:09 PM 1/12/2000 -0700, you wrote:
>We are facing some problem in calls table. Our calls table sometimes
>receive same record twice or thrice. Due to which trigger on Calls run
>twice or thrice so that timeleft field shows irregular data.
>We are using PortMasters 2 as access server. Any ideas....
>
>Salman
>
>For more information about this list (including removal) go to:
>http://www.iea-software.com/support/maillists/liststart

----------------------------
hostmaster@interaxs.net
www.interaxs.net
InterNet Access Network
Voice: 937-461-3660 Fax:937-228-2773

For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart

--Regards
Salman Karim

--
For more information about this list (including removal) go to:http://www.iea-software.com/support/maillists/liststart



 Previous message: Dale E. Reed Jr.: "Re: [RadiusNT] Netserver OID"

 Next message: Herman verschooten: "[RadiusNT] .209 <> VSA"
 Maybe in reply to: Salman Karim: "[RadiusNT] Dual Call Records Problem"