*********** REPLY SEPARATOR ***********
On 11/30/99, at 1:12 PM, Josh Hillman wrote:
>From: PowerNet <psc5@powersupply.net>
>Is that it?
>Is that why it's not working since I don't have that?
>Would it be 255.255.255.0 for 1 class C
>
>Only if you're routing an entire class C through them.
>
>Here are the radius defaults for one of our users with a static IP (not
>doing any subnetting) and is also allowed to be on 24/7--that's why
>Ascend-Maximum-Time is not listed for him. Ascend-Idle-Limit is set=
because
>I have it set in our Maxes as 20 minutes by default. The one in radius
>overrides the Max setting because I have "shared profiles" enabled in the
>Maxes.
>
>Name Data
>---------------------- ----------------------
>Ascend-Idle-Limit 0
>Framed-Address 123.123.123.123
>Framed-Netmask 255.255.255.255
>Framed-Protocol PPP
>NAS-Port-Type Async (prevent ISDN)
>User-Service Framed-User
>
>
>Josh
>
>*********** REPLY SEPARATOR ***********
>
>On 11/30/99, at 12:21 PM, Josh Hillman wrote:
>
>>Don't forget FramedNetmask=3D255.255.255.255
>>
>>----- Original Message -----
>>From: PowerNet <psc5@powersupply.net>
>>To: <emerald@iea-software.com>
>>Sent: Tuesday, November 30, 1999 11:59 AM
>>Subject: [Emerald] Radius Attributes, Static IP
>>
>>
>>I have a couple customers with Static IP's
>>I am using Ascend boxes with Emerald and RadiusNT
>>
>>Currently, for dedicated 24/7 customers we have a dedicated account with
>>radius attributes set up in emeraldadmin
>>The attributes are:
>>User Service Framed User
>>Framed Protocol PPP
>>
>>That it, and nothing special is set up in Emer Client for that specific
>>user.
>>The way they get that ip is that we have them specify the ip in their
>dialup
>>network settings. It works that way.
>>
>>This morning I tried to set the address in the radius section of Emer
>>client and then when they logged in I can't ping them and their=
connection
>>does not work. The settings I made this morning were:
>>User Service Framed User
>>Framed Protocol PPP
>>Framed Address x.x.x.x(x=3Dtheir static ip)
>>
>>What am I doing wrong that this won't work. From what I have been told
>this
>>is the way to set it up.
>>
>>Thanks,
>>John
>>
>>
>>For more information about this list (including removal) go to:
>>http://www.iea-software.com/support/maillists/liststart
>>
>>
>>
>>For more information about this list (including removal) go to:
>>http://www.iea-software.com/support/maillists/liststart
>
>For more information about this list (including removal) go to:
>http://www.iea-software.com/support/maillists/liststart
>
>
>
>For more information about this list (including removal) go to:
>http://www.iea-software.com/support/maillists/liststart
For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart