After I added it in, things went a bit smoother.
Regards,
Graeme
---Graeme Slogrove, BSc (Eng) Elec (Wits)Director, Systems Development & Value Added ServicesNetActive InternetTel: 011-719-0333 Fax: 011-719-0444Support: 011-719-0300
-----Original Message-----From: Dale E. Reed Jr. [mailto:daler@iea-software.com]Sent: 22 September 1999 08:25To: radiusnt@iea-software.comSubject: Re: [RadiusNT] Logfile Cleanup
David Sovereen wrote:> > >> Wed Sep 22 02:29:48 1999: Authenticate: from pm3-2.mid1 - No User Name> > >It means that RadiusNT received an authentication request, but> >there was no username in the request. This can happen when the> >dictionarty doesn't intialize properly.> > I just recently (within the past day or two, same time frame as upgradingto> 2.5.195) added those Vendor-Specific attirbutes for Livingston equipment.> Could I have mis-entered something to cause the above? What should I look> for?
Yes. For example if you added the VSA without specifying theVendorID correctly, then it could have that problem.Check out the -x15 debug of the error and see what is actually in the request.
--Dale E. Reed Jr. Emerald and RadiusNT__________________________________________IEA Software, Inc. www.iea-software.com
For more information about this list (including removal) go to:http://www.iea-software.com/support/maillists/liststart
For more information about this list (including removal) go to:http://www.iea-software.com/support/maillists/liststart