Re: [RadiusNT] Enterprise Monitor

Info Desk ( info@olynet.com )
Fri, 28 May 1999 10:06:28 -0700

You have to have the server Ip address added to your radius servers. After
going nuts yesterday over the same problem it all of a sudden accured to me.
You have to think of that server, where Enterprise resides, just like any NAS
server. So what is happening is that Radius does not see that computer as a
valid server IP in the Server table just like any NAS server. Does this make
sense?

Kent Runyan wrote:

> Every time I set this up it says the server timed out.
>
> I used port 1645, a valid username, password and the NAS secret...
>
> Is there something else I mised?
>
> > -----Original Message-----
> > From: radiusnt-request@iea-software.com
> > [mailto:radiusnt-request@iea-software.com]On Behalf Of Info Desk
> > Sent: Friday, May 28, 1999 10:49 AM
> > To: radiusnt@iea-software.com
> > Subject: Re: [RadiusNT] Enterprise Monitor
> >
> >
> > I finally figured it out myself.
> >
> > Kent Runyan wrote:
> >
> > > Has anybody gotten this to monitor Radius yet?
> > >
> > > > -----Original Message-----
> > > > From: radiusnt-request@iea-software.com
> > > > [mailto:radiusnt-request@iea-software.com]On Behalf Of Info Desk
> > > > Sent: Thursday, May 27, 1999 2:58 PM
> > > > To: radiusnt@iea-software.com
> > > > Subject: [RadiusNT] Enterprise Monitor
> > > >
> > > >
> > > > I have just installed Enterprise Monitor 5.0. I am getting a server
> > > > timed out error for both of my radius servers. I have
> > checked the port
> > > > and it is set to 1645 and I am using a valid login name with
> > an invalid
> > > > password. I am obviously missing something. Could somone please give
> > > > me some tips here?
> > > >
> > > >
> >
> >