Re: [Emerald] Database check and others...

Dale E. Reed Jr. ( (no email) )
Thu, 22 Apr 1999 16:35:38 -0700

"S.Tumurbaatar" wrote:
> When I run database check, result window
> shows log messages about each procedure
> has been performed. I'm not MS SQL expert
> (really I started learning it only becouse of Emerald)
> and dont understand some messages. At start
> of message list there're several messages like
> '...pages: change from (xx) to (yy)'. Is it error?

Mainly, if you see an "error" message, then there is an issue.
The page information and table information is not an error.

> Also I cannot delete operators entry from Security|Operators.
> SQL raises some error.

Make sure that operator is not in any groups first.

> And finally, may be, all my problems result from database
> becouse when I'm creating Emerald database with
> Debug check box checked, create procedure always shows
> several errors. I unchecked Debug mode and creation completes
> without any warning.

They are not errors. Debug mode is designed to show any informational
messages that SQL Server sends back (it sends a LOT of them). Those
are not displayed normally. You should not have debug mode enabled
unless you are either having a problem, or support has directed you
to enable it.


Dale E. Reed Jr. Emerald and RadiusNT__________________________________________IEA Software, Inc.