Re: [Emerald] static ip
Tue, 26 Jan 1999 12:23:05 -0600

I didn't see your below settings....however, you need to give them all
the radius attributes they will need. In other words, take your
default attributes add those to the user then add your framed-address
and framed-netmask attributes. If it's an IP that needs a route you
would have to add that as well.

On a side note to Dale.
Can you add a framed address and netmask without adding a framed route
kind of like in the ascend max you can add for example
IP This would assign to the user and
route to

On Tue, 26 Jan 1999 11:21:48 -0600, you wrote:

>I am trying to set up a static ip for a customer.. i have set up emerald=
with the below settings and can call into my ascen max unit ok and get =
the right ip address but i can not ping anything further than that max =
unit. do i need to assign that ip to a pool in the max unit i have three=
units and the call could come in on any of the units so what happens =
when if i set pools to the ascend units with the same ip's?
>Kenneth Jaeger

For more information about this list, including removal,
please see