Re: New install

Mike Rabaut ( rabaut@n44h5.hcc.cc.fl.us )
Tue, 23 Jun 1998 08:37:21 -0400

Hello

I have RadiusNT working but it will not connect to the BayNetworks RAC.

When the RAC boots up, I get the following message on the RadiusNT PC:

Resp Time: 10 Auth: 0/0 -> 0 Access: 1/0/0 ->
radrecv: Request from host XXXXXXX code=4, id=0, length=01
Acct-Status-Type = 7
Acct-Session-Id = "d30d0000"
Acct-Delay_Time = 0
NAS-IP-Address = YYY.YYY.YYY.YYY
Vender-Specific = ""
Vender-Specific = ""
Sending Accounting Ack of id 0 to XXXXXX (YYY.YYY.YYY.YYY)

Response Time : 10 Auth: 0/0 -> 0 Acct: 2/0/0/ -> 2

I can still dialin with any username and password I choose... with no
response from RadiusNT except for the previous info that is given only when
the RAC is re-booted.

I have set the following on the RAC:

pref_secure1_host to the RAC IP address YYY.YYY.YYY.YYY
auth_protocol radius
enable_radius_acct Y
radius_auth_port 1645
radius_acct_port 1646
radius_secret "<set>"
radius_timeout 4
radius_retries 10
radius_acct_level standard
radius_port_encoding device

I have contacted Bay about it and they say the support issie is with IEA
Software...
I went to the IEA site and found a link to BayNetworks and it didn't help at
all..

Thanks

Mike

>Dale E. Reed Jr. (daler@iea-software.com)
>_________________________________________________________________
> IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs
> Internet Solutions for Today | http://www.iea-software.com
>
>
rabaut@hcc.cc.fl.us
Hillsborough Community College
Ybor Campus
P.O. Box 5096
Tampa, Fl 33675-05096