Mike Tsai
Dale E. Reed Jr. wrote:
> Michael Y.C. Ysai wrote:
> >
> > I have test Radius NT in DOS mode and use Access-ODBC database,
> > and it success, but when start service, It seems doesn't work, the user
> > authentication doesn't pass.
> > Are there any reasons?
>
> There could be several. First of, when you run it in foreground
> is the ONLY parameter you are using -x? Also, make sure you
> go into the RadiusNT Admin and define complete paths for
> the accounting and data directories.
>
> > PS. I found the table of access "call" should not mark the field
> > "NASIdentifier" as part of the key,
> > since the insertion of accounting record doesn't metion this field and
> > Access report that a key field should not be NULL, so I fix this and it
> > finally work in DOS mode, Is this a reported bug?
>
> No, thats incorrect. NASIdentifier IS a part of the key.
> If you NAS is not sending either NAS-Identifier or NAS-IP-Address,
> then your NAS is not RFC compliant.
>
> --
> Dale E. Reed Jr. (daler@iea.com)
> _________________________________________________________________
> IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs
> Internet Solutions for Today | http://www.iea-software.com
>
> ----------------------------------------------------------
> RadiusNT Mailing List lists@iea-software.com