So far as I can tell, whenever I start RadiusNT in debug mode and enable
Radius accounting on the Tribelink, RadiusNT receives a report of the
next activity. It claims to send an acknowledgement back to the
Tribelink, but a while later it apparently receives the same accounting
information from the Tribelink again. This continues until I restart the
Tribelink.
What follows is an excerpt from the output of RadiusNT in debug mode. I
have tried everything that I can and now need suggestions. Is it a
problem with our RadiusNT installation or with the Tribelink? Thanks.
--- Output follows ---
Radius NT is ready to receive requests!
radrecv: Request from host ccb83d31 code=4, id=1, length=69
Acct-Status-Type = Stop
Acct-Session-Time = 720
User-Name = "Smith,John"
Acct-Session-Id = "7500000048"
Acct-Delay-Time = 0
Sending Accounting Ack of id 1 to ccb83d31
Response Time: 941
radrecv: Request from host ccb83d31 code=4, id=2, length=69
Acct-Status-Type = Stop
Acct-Session-Time = 720
User-Name = "Smith,John"
Acct-Session-Id = "7500000048"
Acct-Delay-Time = 59
Sending Accounting Ack of id 2 to ccb83d31
Response Time: 540
radrecv: Request from host ccb83d31 code=4, id=3, length=69
Acct-Status-Type = Stop
Acct-Session-Time = 720
User-Name = "Smith,John"
Acct-Session-Id = "7500000048"
Acct-Delay-Time = 128
Sending Accounting Ack of id 3 to ccb83d31
Response Time: 390
---------------------------------------------------
Jim Wagner
Technology Coordinator
Arcadia Valley R-2 School District
Ironton, MO
jwagner@mail.av.k12.mo.us