Re: Radius .49 running as a native service

Serge Stein/i2Tech ( Serge_Stein@i2.com )
17 Dec 96 5:32:02 EDT

Josh Hillman wrote:
>
> I've been trying to run RadiusNT .49 as a native service for some time now,
> unsuccessfully. I had .45 running as a service, using SRVANY for a while
> and never had a problem. Since then, I had uninstalled .45 as a service
> and now run .49 from the command prompt (-x -o -A) in conjunction with my
> Max 4004 and using Emerald (.52) with the SQL 6.5 database. Running .49
> from the command (cmd) prompt runs just fine (except for the fact that it
> doesn't seem to insert some data into a couple of the Calls columns for
> some reason--mentioned in a previous post).
>
> Attempting to start RadiusNT .49 as a service from Control Panel -->
> Services yeilds the following message (after stopping Radius from the
> command prompt):
> Could not start the RadiusNT service on \\GAMMA
> Error 1067: The process terminated unexpectedly.
> [OK]
>
> No messages showed up in the Event Viewer.

Most likely it can't login into the SQL Server. In your setup, you
show
it running as "system". Do you have the system user mapped? When you
run 1.16.49 in interactive mode, who are you logged into NT as? Have
you tried confgiuring the service to run as THAT user?

-- Dale E. Reed Jr.  (daler@iea.com)_____________________________________________________________________ Internet Engineering Associates   |  RadiusNT, Emerald, and NT FAQs  Internet Solutions for Today     |    http://www.emerald.iea.com-RadiusNT Mailing list (radiusnt@iea.com)