Anything else I am missing?
> Date: Fri, 25 Apr 1997 02:19:42 -0700
> From: "Dale E. Reed Jr." <daler@iea.com>
> Organization: IEA Software, Inc.
> To: RadiusNT@emerald.iea.com
> Subject: Re: Radius 1.60 load error
> Reply-to: RadiusNT@emerald.iea.com
> gwatkins@bmmhnet.com wrote:
> >
> > I did setup the admin but if I understand it right that only applies
> > if running as a service. I did not install 60 to run as a service. I
> > am also not running 49 as a service either. I simply setup an item in
> > the startup group to load Radius with the following command line:
>
> No. The RadiusNT sets the "Defaults" for RadiusNT. You can over-ride
> this on the command line for debug. But if you specify options in the
> admin, and just start Radius with "radius -x15" all those are in affect.
>
> > radius -x15 -b
> >
> > This works fine for 49 but not 60.
>
> Do a cut/paste of what follows after this. You may need to go
> into the admin and specify the directory information, though.
> The default typically doesn't work.
>
>
> --
> Dale E. Reed Jr. (daler@iea.com)
> _________________________________________________________________
> IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs
> Internet Solutions for Today | http://www.emerald.iea.com
>
> ----------------------------------------------------------
> RadiusNT Mailing List listserver@emerald.iea.com
>
>