Message-ID: <000701c074da$5a84d080$c1a535cf@ieasoftware.com> From: "Dave Turner" <davet@iea-software.com> Subject: Re: [NTISP] odd problem on a NT40 box Date: Tue, 2 Jan 2001 08:37:53 -0800
If you have the Microsoft Transaction Control module running as part of IIS
(might be called MS DTC), make sure it is running as the right user with the
right permissions as well. Usually it is IWAM_*servername* whereas the HTML
piece of IIS runs as IUSR_*servername* . . . seen that problem before and
the DTC piece was running as a local user without proper rights . . . I set
it to the proper user and the authentication library loaded properly and did
not prompt for username and password any longer.
Dave Turner
System Administrator/Support Engineer
IEA Software
----- Original Message -----
From: "David Payer" <david.payer@ia-omni.com>
To: <ntisp@iea-software.com>
Sent: Friday, December 29, 2000 7:03 PM
Subject: [NTISP] odd problem on a NT40 box
> I recently created a newer NT40 box.
>
> Put option pak 4 on it (IIS4)
>
> Put service pack 5 (couldn't find 6a on microsoft.com)
>
> Installed the FP2k server extensions.
>
> I am running a few web sites on it. When we go to run ANY asp file, we get
> prompted for permission to run the file. If I authenticate with an
> administrator account, it works fine, pushing data into an access file via
a
> form. Without authentication HTML only is ok. I tried even a dummy file
with
> the extension .asp and it causes the same prompt, EVEN WHEN ACCESSING FROM
A
> BROWSER ON THE SERVER ITSELF.
>
> Obviously I have missed a permission somewhere but I can't seem to see it.
> My other server does not have this problem so I know what it should look
> like :)
>
> My system32/inetsrv directory has everyone with full control
>
> Any insights would be appreciated.
>
> David Payer
> OMNI Internet
> www.iowalink.com
>
> Please note that this is a user supported mailing list.
>
> For more information about this list (including removal) go to:
> http://www.iea-software.com/support/maillists/liststart
>
.