RE: [RadiusNT] Ascend Max3000 and Radius Accounting

Denny Figuerres ( (no email) )
Tue, 28 Mar 2000 14:58:02 -0800

Just us chickens out there....

: - )

Work Work Work...

Btw: anyone worked with Cisco VoIP radius packets with Radius NT?? They
have some goofy deal where they
Stuff up to 256 bytes in to Acct-Session-ID. Wonder if aside from modifying
the table if it would make RadiusNT blowup or anything?
Any comments?

Denny Figuerres

-----Original Message-----
[]On Behalf Of Mike Kovacich
Sent: Tuesday, March 28, 2000 2:47 PM
Subject: Re: [RadiusNT] Ascend Max3000 and Radius Accounting

Is this list still active ? I can see my post but have seen only 3 posts
(including mine) since last Friday.

Mike Kovacich wrote:

> I am still trying to successfully get the MAX3000 to send accounting to
> the
> radius server. Authentication is fine. It did work at one time but it
> was
> around the time of entering the license I have not been able to get it
> working
> again. The MAX is sending the accounting packs to the radius server and
> getting refused. Once in a while it is successful starting a record in
> the
> calls table but then unsucessful stopping the call. When there is a
> sucess
> talking to the accounting server it gets only so far as I can follow in
> the
> debug mode with the attributes but it only gets so far and gives a
> Doctor
> Watson error (3 of them).
> The event log says the perfctrs.dll cannot be opened. No doubt surrounds
> the
> server itself, I have already re-installed radius overtop the previous
> install. I am using NT4 sp6a on a P3 450, 120mb of ram.
> --
> Mike Kovacich
> For more information about this list (including removal) go to:

--Mike KovacichSystem

Inter-PC Internet ServicesWarpLink Communications

For more information about this list (including removal) go to:

For more information about this list (including removal) go to: