Re: [RadiusNT] What table?
Dale E. Reed Jr. ( (no email) )
Fri, 24 Mar 2000 09:24:29 -0800
"S.Tumurbaatar" wrote:
>
> Below is a part of RadiusNT2.5's logfile. I have 2 questions
> about it. What table is causing this error? Also why the message
> (user not found) is repeated so much with no delays? If there was
> a few seconds between these logs, I may think that user retyped
> its name or password, but there is almost 0 sec.
>
> Fri Mar 17 18:08:24 2000: User: borchi Not found
> Fri Mar 17 18:08:25 2000: ODBC Error:23000:-1605:
> [Microsoft][ODBC Microsoft Access Driver] The changes you requested to the
> table were not successful because they would create duplicate values in the
> index, primary key, or relationship. Change the data in the field or fields
> that contain duplicate data, remove the index, or redefine the index to
> permit duplicate entries and try again.
This is a duplicate accounting record message. Its not a big deal
unless it happens alot. Check your NAS accounting timeout
settings to make sure they are not too low.
> Fri Mar 17 18:08:25 2000: User: borchi Not found
> Fri Mar 17 18:08:25 2000: User: borchi Not found
Some PPP software will resend the username/password a couple of
times automatically. Most likely that is what you are seeing.
--
Dale E. Reed Jr. Emerald and RadiusNT__________________________________________IEA Software, Inc. www.iea-software.com
For more information about this list (including removal) go to:http://www.iea-software.com/support/maillists/liststart