I installed 3.0, and it didn't require a reboot. I ran it, and it worked
fine until I switched to ODBC mode, at which time, it promptly started
bitching about not being able to find stored procedures 'n stuff.
Back to 2.5 for us, at least until our SQL guy can figure out what the hell
is going on.
-Troy
** -----Original Message-----
** From: radiusnt-request@iea-software.com
** [mailto:radiusnt-request@iea-software.com]On Behalf Of Graeme Slogrove
** Sent: Monday, January 31, 2000 9:03 AM
** To: radiusnt@iea-software.com
** Subject: [RadiusNT] Installing Radius v3.0
**
**
** Trying to install a Radius v3.0 test box on an NT machine.
**
** Every time I run setup, it says some files need to be replaced and the
** system must reboot.
**
** After reboot, I run setup. The same thing happens ...
**
** Groundhog day all over ;)
**
** Regards,
** Graeme
**
** ---
** Graeme Slogrove, BSc (Eng) Elec (Wits)
** Director, Systems Development & Value Added Services
** NetActive Internet
** Tel: 011-719-0333 Fax: 011-719-0444
** Support: 011-719-0300
**
**
**
** For more information about this list (including removal) go to:
** http://www.iea-software.com/support/maillists/liststart
**
**
For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart