RE: [RadiusNT] Does RadiusNT support ip address pools

Derek Gaeth ( (no email) )
Thu, 2 Dec 1999 11:49:59 +1300

OK, So what do I do. I do not have control of a couple of the access
servers as they belong to a telco in another part of the country, and we are
doing proxy authentication. I need to be able to assign a user an ip
address out of an ip pool based on their login name/group. The network
access servers are a mix of cisco and 3COM total control boxes.

Regards,
Derek Gaeth - Internet Technology Specialist
Onthenet Networks Limited, Auckland, New Zealand
mailto:derek@onthenet.co.nz http://www.onthenet.co.nz
Ph:+64-9-414 0300 Mob:+64-21-649 173 Fax:+64-9-414 0999

-----Original Message-----
From: radiusnt-request@iea-software.com
[mailto:radiusnt-request@iea-software.com]On Behalf Of Adam Greene
Sent: Thursday, 2 December 1999 09:51
To: radiusnt@iea-software.com
Subject: Re: [RadiusNT] Does RadiusNT support ip address pools

I think Dale was trying to say that RadiusNT DOES support Pool attributes
like
those for Ascend and Cisco. Correct me if I'm wrong!

Regards,
Adam

>RadiusNT doesn't support pool management itself, but it doesn't support
>Pool attributes, like Ascend and Cisco have (where you define the pools
>on the NAS itself).
>
>--
>
>Dale E. Reed Jr. Emerald and RadiusNT
>__________________________________________
>IEA Software, Inc. www.iea-software.com
>

For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart

For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart